Concrete Remover effectively removes concrete splatters and deposits from construction vehicles, equipment, tools and commercial surfaces. Not intended for use on fine automotive finishes. Always pre-test undiluted product in an inconspicuous area, to determine safety and suitability for the intended use.
Dilution Ratio:
- 1:1, 5 gallons makes 10 gallons
To Apply: Spray diluted solution on surface and allow to penetrate, but not dry. Apply detergent from the bottom up and rinse from the top down.
Directions: INDUSTRIAL USE ONLY. Read the Safety Data Sheet thoroughly before using this product. Do not pre-wet surfaces to be treated, as this will decrease the rate of concrete removal. Apply Concrete Remover undiluted to affected areas, using a pump sprayer or a soft chemical-resistant bristle brush. For fresh light splatters, dilute product 1:1 (pH 2.0 at dilution). Allow 15 minutes dwell time for concrete to soften. Rinse surfaces thoroughly with fresh clean water. Use of a high pressure washer will assist with removal and rinsing. Allow all surfaces to dry before the re-treatment of any heavier concrete deposits.
Benefits:
- Safe for Use on Most Painted Metal Surfaces
- Save Time by Working Fast
- Economical – Can be Diluted 1:1 for Fresh Light Splatters
- Phosphate Free
Technical Data:
- Color: Light Yellow
- Scent: Sharp
- Foam 1-5: 3 = Medium
- Reaction in Hard Water 1-5: 3 = Average
- pH at Full Strength: 2.2
- pH at use Dilution(1:1 ratio): 2.0
5 Gal 8.698-181.0
55 Gal 8.698-182.0
